Dimensions from patent drawings

Typically I draw a dimension to the center point of the slot, rather than to both ends of it, but there is no harm in doing it this way

Dimensions from patent drawings A slot is really just an elongated hole, so first you'd need to know the hole diameter Then you can either call out the dimension from center-to-center on the

Typically I draw a dimension to the center point of the slot, rather than to both ends of it, but there is no harm in doing it this way

slot sleutel Pre-selecting sketch curves and then applying slot creates slots of equal size across all curves, lines, or arcs, linked together with one single dimension You

points, lines, or surfaces to enable the dimensions to be placed outside the outline wherever Number and pitch of slots to be stated Dimensional

slot panda the art of technical drawing net Holes and Hole Dimensions

The 20 wide slot on these drawings is directly toleranced rather than controlled indirectly with a profile of a surface tolerance A half dimension could not